Elegoo MARS 4 Series Manual del usuario - Página 3
Navegue en línea o descargue pdf Manual del usuario para Impresoras 3D Elegoo MARS 4 Series. Elegoo MARS 4 Series 20 páginas.
También para Elegoo MARS 4 Series: Manual del usuario (20 páginas)
Imprimir página
Notice:
If you need technical support, please contact us at
Please keep the Mars 4 series 3D printer and its accessories out of the reach of
children.
When you use the printer for the first time, you would need to level the build
platform before printing.
If the printing fails, you need to clean the excess cured resin in the resin tank
and change the resin, otherwise it may cause damage to your printer.
Please fill not less than 1/3 of the resin tank, but do not exceed the
MAX line position.
Please use 95% (or higher) ethyl alcohol or isopropyl alcohol to wash your
model unless you are using water washable resin.
Please use the printer indoors and avoid direct sunlight and a dusty environment.
Please keep your printer away from water or a damp environment.
Please wear a mask and gloves before use to avoid direct skin contact.
Please do not disassemble the Mars 4 series 3D printer by yourself, otherwise
the warranty will expire.
If the release film in the resin tank is whitened or the printing failure rate is high,
please replace the release film in time.
If you have any problems with the printer, please contact us at [email protected],
and if you run into an emergency during use, please turn off the power supply of
the printer first.
Please keep the box for 30 days for return/exchange shipping (only original Elegoo
boxes will be accepted)
(Unbox and Test)