- ページ 3

3Dプリンター Elegoo MARS 4 SeriesのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Elegoo MARS 4 Series 20 ページ。
Elegoo MARS 4 Series にも：ユーザーマニュアル (20 ページ)

Notice:

If you need technical support, please contact us at

Please keep the Mars 4 series 3D printer and its accessories out of the reach of

children.

When you use the printer for the ﬁrst time, you would need to level the build

platform before printing.

If the printing fails, you need to clean the excess cured resin in the resin tank

and change the resin, otherwise it may cause damage to your printer.

Please ﬁll not less than 1/3 of the resin tank, but do not exceed the

MAX line position.

Please use 95% (or higher) ethyl alcohol or isopropyl alcohol to wash your

model unless you are using water washable resin.

Please use the printer indoors and avoid direct sunlight and a dusty environment.

Please keep your printer away from water or a damp environment.

Please wear a mask and gloves before use to avoid direct skin contact.

Please do not disassemble the Mars 4 series 3D printer by yourself, otherwise

the warranty will expire.

If the release ﬁlm in the resin tank is whitened or the printing failure rate is high,

please replace the release ﬁlm in time.

If you have any problems with the printer, please contact us at [email protected],

and if you run into an emergency during use, please turn oﬀ the power supply of

the printer ﬁrst.

Please keep the box for 30 days for return/exchange shipping (only original Elegoo

boxes will be accepted)

(Unbox and Test)