anko HEG20MF Manual del usuario - Página 15
Navegue en línea o descargue pdf Manual del usuario para Ventilador anko HEG20MF. anko HEG20MF 16 páginas. 20cm misting fan
Imprimir página
6 Troubleshooting
Common problems
No Power to the unit (Power
button light not lighting up)
Appliance automatically turns
off after 1, 2 or 3 hours.
Not much Mist is being emitted
Too much Mist is being emitted
Mist functions keeps turning off
or no Mist is generated
Water dripping occasionally
from the Mist Generators
Water continuously dripping
from the Mist Generators
Cause
Power Not Switched On.
The
power
supply
connected to the appliance.
(Power Supply Not Included)
The Auto Off Timer has been
set
The mist level is set to Low.
The mist level is set to High.
All Water has been consumed
This is normal depending on
the ambient humidity etc.
Water other than Tap Water
may have been used.
Page 15 of 16
Plug in the power supply and
switch it On at the power point.
If still no power, check if the
power
point
supplied
another appliance such as a
table lamp.
If no power to the power point,
call an electrician.
Insert the small plug end on the
is
not
USB cable into the back of the
appliance, and the large end of
the USB cable into the Power
Supply.
Only set the Auto Off timer if
you wish to have the appliance
automatically turn off.
Refer to the Mist" section for
Instructions.
Refer to the Mist" section for
Instructions.
Refill the Water tank and then
turn on the Mist Function
Either turn off the Mist Function
or place an absorbent cloth or
a tray under the appliance to
catch the drips.
DO NOT use Demineralised
Water or Distilled Water.
Only use Tap Water.
Remedy
has
power
by
checking
with