anko LD-K1045 Manual del usuario - Página 5
Navegue en línea o descargue pdf Manual del usuario para Hervidor anko LD-K1045. anko LD-K1045 7 páginas. Cordless water kettle
Imprimir página
First time use
IMPORTANT! During the below process, DO NOT fill the kettle more than the MIN. (0.5L) mark on the
kettle.
Filling above the min. mark will cause over boil and spillage out of the spout.
To ensure a long service life of the water kettle and to remove any residue from manufacturing process,
proceed as follows before using it for the first time:
1. Fill the kettle with water and add vinegar in a ratio of 1:3 (1 part vinegar / 3 parts water).
Note: Make the mixture in a separate container and then pour into the kettle, not more than the MIN.
(0.5L) mark.
2. Bring to a boil (see Boiling water), then pour away.
3. Allow the kettle to cool down and then refill it fresh water, boil the water and then pour it away again
To avoid scale deposits, descale the water kettle at regular intervals (after about every 15th use)
as described in the section "Descaling".
The appliance can heat water to 80℃, 85℃, 90℃, 95℃, 100℃ (boil) and has a keep warm function (Note: keep
warm function cannot be used when 100℃ boiling function is selected).
When the appliance is connected to mains power, all lights will be ON, and the appliance is in standby status.
All the lights will switch OFF, if the appliance is not used after 5 minutes. If you touch any of the buttons, all
the lights will switch back ON again to indicate standby status.
1. Heating water
a. Press the button for 80℃ in standby status, and the corresponding LED light will flash to indicate the water
is heating up. The appliance will start to heat the water till it reaches the selected temperature. The LED
light will stop blinking and remain steady ON when the water in the kettle has reached the selected
temperature. The LED indicator light will turn OFF automatically after five minutes.
b. The same working procedure applies to 85℃, 90℃, 95℃ and 100℃ function.
2. Heat water and keep warm
c. Press the button for 80℃ first, then press the keep warm button. The LED light for 80℃will flash while the
keep warm button will be illuminated. The LED light will stop blinking and remain steady ON when the
water in the kettle has reached the selected temperature. The appliance will stay in keep warm status for 30
minutes.
NOTE: During keep warm function, the kettle will switch ON & OFF to maintain the selected water
temperature. This is normal.
d. The same working procedure applies to 85℃+ keep warm, 90℃ + keep warm, 95℃ + keep warm.
e. If the appliance is in the keep warm state and the body is removed from the base, the keep warm function
will be paused and the keep warm LED will flash. Put the body back in 5 minutes, and the keep warm
function will continue. Otherwise, the appliance will shut down.
NOTE: The keep warm function cannot be selected when boiling water at 100℃.
Boiling water
WARNING! Risk of fire and burns:
* The kettle body and its lid become hot while in use. Do not touch them.
* The lid must be tightly closed during the boiling process. It must not be opened while pouring water out.
Let the appliance cool down before opening the lid.
CAUTION! – boiling water can cause damage to property and cause injuries.
* Do not fill the water container with less than MIN. (0.5L) or more than MAX. (1.5L) of water.