Dry-Matic DM15D Manual de instrucciones - Página 7
Navegue en línea o descargue pdf Manual de instrucciones para Controlador de temperatura Dry-Matic DM15D. Dry-Matic DM15D 16 páginas. Digital controller
Imprimir páginaDry-Matic Installation Instructions
2. Assembly of Unit
floor.
FAN: Mount fan brackets to side of fan.
HEATER (on heated models): Fit to inlet of fan using 4 screws provided
(note airflow direction for fan is shown by an arrow on the terminal
cover). Ensure airflow direction arrow on heater is the same as
direction on fan, ensure heater is mounted so marked top is installed
upright. Ensure heater is level.
FILTER BOX: Fit to heater (on heated models), or fit to the fan using the
supplied collar, so that the hanging bracket is on the heater/fan inlet
side. Ensure airflow direction arrow on filter is same as fan.
PRE FILTER: Fit white pre filter bag to inlet of filter box.
3. Pre Wiring
Using supplied flying leads, connect attic control unit to fan
and heater (on heated models). Check wiring diagrams on components
carefully.
4. Installing in Attic
cup hooks (x2) to roof structure. Clip supplied bungies (x3) to the three
mounting points on assembled unit. Lift unit into position and hook other
end of bungy cords over cup hooks. Attach duct to fan outlet, taping core
and insulation/outer as before. Adjust length of bungies so unit is level and
tighten cable ties to lock unit into position.
5. Mount Attic and Hall Controllers
controller position (as above), attach to hall controller and attic controller.
6. Power Supply
(by registered electrician).
Commission the unit
7. Set up the unit
pp10-13
8. Check Operation
operating instructions pp4-5.
DM - Operating Instructions, Installation Instructions, Wiring diagrams
It is suggested that this is done in a clear space on the
Lift assembled unit into attic space. Fit supplied
Connect a power supply to attic controller isolating switch
using the hall controller, as per commisioning instructions
check the unit is operating correctly, as for user
Run supplied cat 5 patch lead to hall
See next page
for installation
schematic
(continued)
Version 3.1.765 August 2019
7