Anova C1061 Instrucciones de montaje - Página 2

Navegue en línea o descargue pdf Instrucciones de montaje para Mobiliario exterior Anova C1061. Anova C1061 2 páginas.

5. The remaining Bench Seat becomes the Bench Back. Align the mounting holes in one of the Bench Supports with the holes in the

appropriate end of the Bench Back. Install a Washer onto one of the Bolts and insert the Bolt through both parts, with the Bolt

head on the outside surface of the Bench Support. Install a Washer and Nut on the inside end of the Bolt.

Leave the hardware finger tight so

that adjustments can be made to

the Bench Back.

Install a Bolt and Washer through

the other set of mounting holes in

that end of the Bench Support and

Back and install a Washer and Nut.

Again, leave the hardware finger

tight.

6. Attach the other Bench Support to

the Bench Back as shown. Leave

the hardware finger tight.

7. Tighten the Bench hardware using

the Open End or Box End Wrench

and Ratchet Wrench; minor

adjustments can be made while

tightening the hardware to make

the Seat and supports square.

8. Determine the location for bench, locate

underground utilities and avoid them while digging

holes for concrete bases.

9. The walls of the concrete base should be vertical and

smooth to minimize the effects of frost upheaval.

This can be achieved with the use of concrete forms,

such as Sonotube. Consider extending the concrete

base below the frost line to eliminate the possibility

of frost upheaval. Consult a professional for loose or

unusual soil conditions.

10. Create a temporary structure that will be used to

support the bench, at the desired height and level,

while the concrete is curing.

11. Fill forms with concrete and insert supports,

centered in concrete, until bench is supported by

the temporary structure. Allow supports to fill

with concrete. Crown the concrete cap to optimize

drainage.

12. After concrete has cured remove temporary

structure and retighten all hardware.

•

Furniture must not be used other than for its intended purpose and should be inspected regularly for loose,

missing, or broken hardware, and general instability.

•

Furniture that is damaged or appears to be unstable must be removed from service and be repaired or replaced.

wArnInG

•

Repairs must be made using only factory authorized parts and methods.

cAre AnD

•

Do not drag the assembled unit across any surface.

mAIntenAnce

•

This product requires only periodic cleaning with a sponge and a solution of mild detergent and water to

remove surface dirt. Do not clean with a solvent or petroleum based products.

211 No

St. Louis, MO 63141

rth Lindbergh Blvd.

Bench Back

18.38"

12.00"

tel: 888.535.5005

web: anovafurnishings.com

Bench

Support

Washer

Bolt

Nut

Washer

20.38"

10/2012