Anova C1061 Petunjuk Perakitan - Halaman 2
Jelajahi secara online atau unduh pdf Petunjuk Perakitan untuk Perabotan Luar Ruangan Anova C1061. Anova C1061 2 halaman.
Halaman Cetak5. The remaining Bench Seat becomes the Bench Back. Align the mounting holes in one of the Bench Supports with the holes in the
appropriate end of the Bench Back. Install a Washer onto one of the Bolts and insert the Bolt through both parts, with the Bolt
head on the outside surface of the Bench Support. Install a Washer and Nut on the inside end of the Bolt.
Leave the hardware finger tight so
that adjustments can be made to
the Bench Back.
Install a Bolt and Washer through
the other set of mounting holes in
that end of the Bench Support and
Back and install a Washer and Nut.
Again, leave the hardware finger
tight.
6. Attach the other Bench Support to
the Bench Back as shown. Leave
the hardware finger tight.
7. Tighten the Bench hardware using
the Open End or Box End Wrench
and Ratchet Wrench; minor
adjustments can be made while
tightening the hardware to make
the Seat and supports square.
8. Determine the location for bench, locate
underground utilities and avoid them while digging
holes for concrete bases.
9. The walls of the concrete base should be vertical and
smooth to minimize the effects of frost upheaval.
This can be achieved with the use of concrete forms,
such as Sonotube. Consider extending the concrete
base below the frost line to eliminate the possibility
of frost upheaval. Consult a professional for loose or
unusual soil conditions.
10. Create a temporary structure that will be used to
support the bench, at the desired height and level,
while the concrete is curing.
11. Fill forms with concrete and insert supports,
centered in concrete, until bench is supported by
the temporary structure. Allow supports to fill
with concrete. Crown the concrete cap to optimize
drainage.
12. After concrete has cured remove temporary
structure and retighten all hardware.
•
Furniture must not be used other than for its intended purpose and should be inspected regularly for loose,
missing, or broken hardware, and general instability.
•
Furniture that is damaged or appears to be unstable must be removed from service and be repaired or replaced.
wArnInG
•
Repairs must be made using only factory authorized parts and methods.
cAre AnD
•
Do not drag the assembled unit across any surface.
mAIntenAnce
•
This product requires only periodic cleaning with a sponge and a solution of mild detergent and water to
remove surface dirt. Do not clean with a solvent or petroleum based products.
211 No
St. Louis, MO 63141
rth Lindbergh Blvd.
Bench Back
18.38"
12.00"
tel: 888.535.5005
web: anovafurnishings.com
Bench
Support
Washer
Bolt
Nut
Washer
20.38"
10/2012