DryGuy Thermanator DG2 Manual de instrucciones - Página 5

Navegue en línea o descargue pdf Manual de instrucciones para Secadora DryGuy Thermanator DG2. DryGuy Thermanator DG2 8 páginas. Silent boot, shoe and glove dryer

Imprimir página

LIST OF COMPONENTS

• DryGuy

Thermanator

™

• Stands – 1 piece

• Plastic saddle clamps with self locking nuts – 2 sets

• Hex wrench – 1 piece

• 1" screws – 4 pieces

• 2" screws – 6 pieces

• Plastic wall anchor – 4 pieces

• Wall mounting brackets – 2 pieces

• Screw cover – 4 pieces

ASSEMBLY AND MOUNTING INSTRUCTIONS

self sTANdINg INsTRUcTIONs:

• Locate the two stands, two plastic saddle clamps and the two self locking nuts.

• Place the upper saddles over the top of the main metal tube, as illustrated, and push the bolts through

the lower saddle clamp, pinning the main metal tube in-between.

• Guide the stands onto each set of bolts as illustrated (See Fig. 1) and semi-tighten the four self-locking

nuts.

• Position the stand so the toe of the boot or shoe is the highest point.

• Adjust DryGuy

™

• Firmly tighten the four self locking nuts with hex wrench which is provided.

WAll MOUNTINg INsTRUcTIONs:

• Wall mount installation does not require stands.

• Locate the two plastic saddle clamps, two self locking nuts and two metal wall-mount brackets.

• Place the upper saddles over the top of the main metal tube, as illustrated, and push the bolts through

the lower saddle clamp, pinning the main metal tube in-between.

• Guide the wall-mount brackets onto the bolts and semi-tighten the four self locking nuts.

with power cord – 1 piece

™

Thermanator

as necessary to an upright position.

™

dryguy.com

Fig 1