Anova MG3514 Manual de instrucciones - Página 8

Navegue en línea o descargue pdf Manual de instrucciones para Motosierra Anova MG3514. Anova MG3514 19 páginas.

4. MACHINE PARTS

1. front protection

2. starter puller

3. Air filter

4. Throttle

5. throttle lock

6. rear handle

7. Throttle

The standard chain saw package contains the following items:

(1) Motor (2) Sword protector cover

(3) Cutting Chain (4) Cutting Sword

(5) Adjustment screwdriver (6) Spark plug wrench

(7) Support claw

Open the box and install the bar and chain on the motor unit as follows:

The chain has sharp edges. Wear protective gloves for your safety.

1. Pull the guard towards the front handle to check that the chain brake is

not on.

2. Loosen the nut and remove the chain cover. Attach the spiked bumper

with two screws at the forefront of the chainsaw.

3. Remove chain spacer.

4. Put the bar on the motor unit and then push towards the clutch.

5. Fit the chain to the bar, on the chain sprocket to the sprocket and

around the bar.

6. Adjust the position of the chain tensioner pin, and then insert the tensioner pin into the lower hole of the bar

guide bar. Mount the clutch cover to the motor unit and tighten the mounting nut. While holding the nose of the

bar, adjust the chain tension by turning the tensioner screw until the retaining straps touch the bottom of the bar

rail.

8. close button

9. off switch

10. Fuel tank

11. Oil deposit

12. Carrying handle

13. String

14. Sword