DAITEM SH148AX Manual de instalación - Página 5

Navegue en línea o descargue pdf Manual de instalación para Sensores de seguridad DAITEM SH148AX. DAITEM SH148AX 18 páginas. Outdoor ir anti-masking 5 m

Imprimir página

3. Recognition programming

IMPORTANT
• The device does not need to be placed close to the control panel for recognition programming. In fact, we advise you to move the
product at least 2 metres away from the control panel.
• The detector n° is allocated automatically by the control panel during recognition programming.
This operation allows the control panel to recognise the detector.
1. For detector recognition programming, the control panel must be in installation mode. If it is not, ask the user to enter:
master code (factory: 0000)
2. Proceed as follows for recognition programming:
then
Press and hold the "test"
#
Press
then
on
*
button until the control
the control panel
panel responds.
keypad.
IMPORTANT: the control panel issues three short beeps to indicate a programming error. When this happens, programming must
be performed again from the beginning.
then
installer code (factory: 1111)
"detector X"
"group ?"
* depending on the
10 s max.
Select the group from 1 to
8*. Use the control panel
keypad to do this.
"time delay?"
*
to
to
type of control panel
Select the time delay:
0: immediate
1: delayed
2: combined
Use the control panel
keypad to do this.
19
"beep, installation
mode"
"beep, detector X,
group Y, immediate
(or delayed
or combined)"
The control panel
issues a voice
message to confirm
detector recognition
programming.
GB