DAITEM SH148AX 설치 매뉴얼 - 페이지 5

{카테고리_이름} DAITEM SH148AX에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DAITEM SH148AX 18 페이지. Outdoor ir anti-masking 5 m

3. Recognition programming

IMPORTANT

• The device does not need to be placed close to the control panel for recognition programming. In fact, we advise you to move the

product at least 2 metres away from the control panel.

• The detector n° is allocated automatically by the control panel during recognition programming.

This operation allows the control panel to recognise the detector.

1. For detector recognition programming, the control panel must be in installation mode. If it is not, ask the user to enter:

master code (factory: 0000)

2. Proceed as follows for recognition programming:

then

Press and hold the "test"

Press

then

button until the control

the control panel

panel responds.

keypad.

IMPORTANT: the control panel issues three short beeps to indicate a programming error. When this happens, programming must

be performed again from the beginning.

then

installer code (factory: 1111)

"detector X"

"group ?"

* depending on the

10 s max.

Select the group from 1 to

8*. Use the control panel

keypad to do this.

"time delay?"

type of control panel

Select the time delay:

0: immediate

1: delayed

2: combined

Use the control panel

keypad to do this.

"beep, installation

mode"

"beep, detector X,

group Y, immediate

(or delayed

or combined)"

The control panel

issues a voice

message to conﬁrm

detector recognition

programming.