DSC Classic PC1565 Manual rápido - Página 10

Navegue en línea o descargue pdf Manual rápido para Control Panel DSC Classic PC1565. DSC Classic PC1565 18 páginas. Security control panels

Imprimir página

Wiring

Wiring SAB

These bell diagrams indicate how to

connect various bells to the Classic

PC1565. Take note that the strobe

should be connected to PGM 1 and

this is programmed as default for your

strobe connection.

The bell circuit on the Classic PC1565

is always supervised with a 1K resistor.

Bell/Panel Tamper Connections

Using a Relay

Wiring SAB

Basic Programming

Once you press [#] to exit section

005, the keypad will again display

"Enter Section" followed by three

dashes.

If you want to make changes to

another section, then enter that new

section number. If you want to exit

engineering mode, simply press [#]

once more and the keypad will revert

to normal mode.

Let's look at changing the default

setting of single end of line resistors

to our recommended double end of

line resistors.

Open the Installation Manual to page

29/30, and find section 013, First

System Option Code; section 013 is a

toggle option section. Section 013 will

be displayed on the LCD keypad as 2

lines, the first line displays "Toggle

Option" and the second line displays

which options are toggled "ON" or

"OFF". If a number appears, that

option is "ON". If a dash is displayed it

means that option is "OFF". If you are

using the LED keypad this will be

illustrated by the zone LEDs "ON" or

"OFF". We see that option 2 is "OFF"

because we see a dash, not a number.

Looking at section 013 in the

worksheets we see option 2 "OFF" in

section 013. This means that the

panel is set up for single end of line

resistors. If the option were "ON", the

number 2 would appear and the panel

would be set for double end of line

resistors.

Basic Programming