DSPM UniMeasure HX-VP510 Series Manual de instalación - Página 2

Navegue en línea o descargue pdf Manual de instalación para Transductor DSPM UniMeasure HX-VP510 Series. DSPM UniMeasure HX-VP510 Series 3 páginas.

Imprimir página

HX-VP510 Series Installation Guide

Model HX-VP510

Velocity

The tachometer is self en er giz ing and requires no input voltage.

Excitation Voltage ..........4.9 to 30 VDC

Excitation Current ..........40 mA max.

Output Impedance .........10 Ω max.

Output Load...................5KΩ min.

RANGE

Note: Di men sions in

2", 10"

brackets are mil li me ters.

3", 15", 30"

4", 20", 40"

5", 25", 50"

60"

80"

Alternate Wire Rope Exit

Via Paolo Uccello 4 - 20148 Milano

Tel +39 02 48 009 757 Fax +39 02 48 002 070

Wiring and Circuit Diagram

Dimensional Information

NOTE

Mount with Ø.25 or M6

Socket Head Cap Screws.

Alternate Wire Rope Exit

"A"

"B"

"C"

1.12 (28.4)

1.79 (45.5)

1.21 (30.7)

.96(24.4)

1.95 (49.5)

1.37 (34.8)

.80 (20.3)

2.11 (53.6)

1.53 (38.9)

.64 (16.3)

2.27 (57.7)

1.69 (42.9)

.49 (12.4)

2.42 (61.5)

1.84 (46.7)

.25 (6.4)

2.66 (67.6)

2.08 (52.8)

As shown in the diagram above, both commons on pins "B" and "C"

are con nect ed to geth er in ter nal ly at the transducer, so that either a

3-wire or 4-wire con nec tion to the trans duc er may be made.

With small blade type screwdriver (.105" max. blade width X .023"

max. blade thickness), adjust the Zero and Span controls on the

trans duc er to set zero output voltage and max i mum output volt-

age. Note: The Zero and Span con trols are some what interactive

and may require sev er al it er a tions to ob tain the desired zero and

maximum settings.

Extend the cable (on angular position transducers, ro tate shaft) of

the trans duc er to the de sired zero position (must be within 0% to

30% of range.) Adjust the Zero control so that the output voltage

is zero. Then extend the cable (on angular position transducers,

ro tate shaft) to the desired max i mum position (must be within 80%

to 100% of range.) Adjust the Span control for max i mum output

voltage required (unit will adjust from 5 VDC to 10 VDC). Re check

the zero set ting and ad just if nec es sary. Recheck the Span set ting

and re ad just if nec es sary.

NOTE

Mount with Ø.50 or M12 Socket Head Cap Screws.

Alternate Wire Rope Exit

[email protected] www.dspmindustria.it