DTAR Wave-Length Manual de instrucciones de instalación - Página 13
Navegue en línea o descargue pdf Manual de instrucciones de instalación para Transductor DTAR Wave-Length. DTAR Wave-Length 16 páginas. Under saddle transducer
Imprimir página
Installing the Optional Volume & Tone Module (Not Included)
We recommend that the V&T Module be installed by a qualified
technician or luthier. The V&T Module installation is best
performed prior to installing the pickup in the guitar. If the unit
has already been installed in the instrument, it will be necessary
to remove the pickup from the saddle slot, being careful not to
damage or distort the pickup in any way. Next, separate the
battery holder from the guitar body. Finally, remove the outer
fasteners of the end pin jack and carefully remove the entire
pickup/preamp assembly from the guitar.
1.
Remove the chassis cover by removing the two screws.
2.
Remove the jumper wire indicated in the illustration below.
3.
Solder the V&T Module cable following the color code in the
illustration below.
www.dtar.com
13
|