Attop X-PACK 10 Manual del usuario - Página 3
Navegue en línea o descargue pdf Manual del usuario para Cuadricópteros Attop X-PACK 10. Attop X-PACK 10 6 páginas.
8.Using the Remote Controller
Left Control Stick
Right Control Stick
9. Aircraft Functions
(1) Speed Switch
The drone is set to low speed by default.
Press the
button once for medium speed and there are two
beeps from the controller. Press it again for high speed and there are
three beeps from the controller.
Press it the third time to get back to low speed and there is one beep
from the controller.
(2) Headless Mode
Short press the
button to activate Headless Mode; LEDs on the
drone start flashing.
In this mode, the drone will fly following the direction of the Right Control
Stick regardless of the position of your drone's head or tail.
Forward
Backward
Standard Mode
Press the same button to exit this mode; LEDs on the drone turn to
solid on.
Push the Left Control
Stick forward, the
drone will ascend;
pull it backward and
the drone will descend.
Head
Pull the Left Control
Stick leftward, the
drone will rotate to the
left; pull it rightward
,the drone will
rotate to the right.
Tail
Push the Right Control
Stick forward, the
drone will fly forward;
pull it backward,
the drone will fly
backward.
Pull the Right Control
Stick leftward , the
drone will fly leftward;
pull it rightward ,
the drone will fly
rightward.
8
Head
Head
Tail
Tail
Headless Mode
10
Flight Trimming
FLIGHT OPERATION GUIDE
IMPORTANT
* Make sure that you power on your drone first, and then turn on the
controller before each flight.
* Please repeat the pairing and calibration procedure each time while the
drone or controller is restarted.
* For all flight functions and modes, the operator and tail of the drone
must be aligned.
(3) 360° Flip
Fly the drone to a height over 2m, then press the
activate 360° Flip function. Next, move the Right Control Stick to flip
the drone accordingly.
Note:
* There are continuous beeps from the remote when you activate this
function. If you do not move the Right Control Stick about 5s after
you press the
button, the function will be cancelled and the
remote will stop beeping.
* This function can't be activated when the battery of the drone is low.
If the drone drifts
forward or backward
when hovering, press
the Backward Trim
button or the Forward
Trim button to adjust.
If the drone drifts
leftward or rightward
when hovering, press
the Rightward Trim
button or the Leftward
Trim button to adjust.
9
button to
2
1
11