Attop X-PACK 10 사용자 설명서 - 페이지 3

{카테고리_이름} Attop X-PACK 10에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Attop X-PACK 10 6 페이지.

페이지 인쇄

8.Using the Remote Controller

Left Control Stick

Right Control Stick

9. Aircraft Functions

(1) Speed Switch

The drone is set to low speed by default.

Press the

button once for medium speed and there are two

beeps from the controller. Press it again for high speed and there are

three beeps from the controller.

Press it the third time to get back to low speed and there is one beep

from the controller.

(2) Headless Mode

Short press the

button to activate Headless Mode; LEDs on the

drone start flashing.

In this mode, the drone will fly following the direction of the Right Control

Stick regardless of the position of your drone's head or tail.

Forward

Backward

Standard Mode

Press the same button to exit this mode; LEDs on the drone turn to

solid on.

Push the Left Control

Stick forward, the

drone will ascend;

pull it backward and

the drone will descend.

Head

Pull the Left Control

Stick leftward, the

drone will rotate to the

left; pull it rightward

,the drone will

rotate to the right.

Tail

Push the Right Control

Stick forward, the

drone will fly forward;

pull it backward,

the drone will fly

backward.

Pull the Right Control

Stick leftward , the

drone will fly leftward;

pull it rightward ,

the drone will fly

rightward.

Head

Tail

Headless Mode

Flight Trimming

FLIGHT OPERATION GUIDE

IMPORTANT

* Make sure that you power on your drone first, and then turn on the

controller before each flight.

* Please repeat the pairing and calibration procedure each time while the

drone or controller is restarted.

* For all flight functions and modes, the operator and tail of the drone

must be aligned.

(3) 360° Flip

Fly the drone to a height over 2m, then press the

activate 360° Flip function. Next, move the Right Control Stick to flip

the drone accordingly.

Note:

* There are continuous beeps from the remote when you activate this

function. If you do not move the Right Control Stick about 5s after

you press the

button, the function will be cancelled and the

remote will stop beeping.

* This function can't be activated when the battery of the drone is low.

If the drone drifts

forward or backward

when hovering, press

the Backward Trim

button or the Forward

Trim button to adjust.

If the drone drifts

leftward or rightward

when hovering, press

the Rightward Trim

button or the Leftward

Trim button to adjust.

button to