Auber Instruments WS Series Manual rápido

Navegue en línea o descargue pdf Manual rápido para Controlador de temperatura Auber Instruments WS Series. Auber Instruments WS Series 15 páginas. Programmable pid temperature controller with dual probe
También para Auber Instruments WS Series: Manual rápido (14 páginas), Manual de instrucciones (18 páginas), Manual de instrucciones (18 páginas), Manual rápido (14 páginas)

Imprimir página

Auber Instruments WS Series Manual rápido

Programmable PID Temperature Controller with Dual Probe

Introduction

Thank you for purchasing the Auber WS series temperature controller. We sincerely

appreciate your decision and trust that our machine will meet your expectations in both

the quality of the result and the value of our product. While we are delighted that you may

be anxious to operate the controller for your project, a few minutes of your time reading

through this manual will only serve to enhance your experience in the months and years

ahead. In particular, we urge you to read through the safety warnings below. Although

this plug-and-play controller is very easy to operate, the process involves high

temperature and high wattage appliances and your safety is paramount.

• This controller is designed only to be used with devices that have limited power

and their own thermal cut off protection, such as a thermostat or thermal fuse in

case of controller failure.

• Do not place any objects on the top of controller surface which is used to vent

excess heat during its operation.

• The maximum electric current this controller can handle is 15 ampere. For 120

volt AC in US and Canada, this limits the heater power to 1800 watts.

• Always place the sensor in the controlled subject when the controller is on. Before

turning on the controller, please make sure the sensor is placed inside the

container to be controlled. Leaving the sensor outside of the solution will form an

open loop operation. If the sensor is left outside, controller will assume the

temperature is low even if the controlled subject is already very hot. The controller

will provide full power to the heater. It will not only overheat the controller, but also

damage your appliance, and even cause a fire.

• This controller is designed to control the devices recommended by Auber

Patent pending

No part of this manual shall be copied, reproduced, or transmitted in any way without the prior, written consent of Auber Instruments.

Auber Instruments retains the exclusive rights to all information included in this document.

Quick Guide for WSD-1510GPH

Version 1.0 (June, 2019)

Auber Instruments

5755 North Point Parkway, Suite 99

Alpharetta, GA 30022

770-569-8420

www.auberins.com

SAFETY WARNINGS