Auber Instruments WS Series Manual de instrucciones - Página 5
Navegue en línea o descargue pdf Manual de instrucciones para Controlador Auber Instruments WS Series. Auber Instruments WS Series 18 páginas. Programmable pid temperature controller with dual probe
También para Auber Instruments WS Series: Manual rápido (15 páginas), Manual rápido (14 páginas), Manual de instrucciones (18 páginas), Manual rápido (14 páginas)
Imprimir página
Plug the temperature sensor to the back of the controller.
Plug the power cord to the power outlet on the wall.
Turn on the controller to make sure the controller powers up properly, and the
temperature display is in the range expected. Then, turn off the controller.
Plug the heater to the back of the controller. If the heater has a switch, put it in the
off position. Put the sensor inside the container to be controlled.
Turn on the controller.
Turn on the heating device.
Remark The connector of sensor contains a slot for correct pin connection. It also has a
spring lock to prevent disconnections from accidental pulling on the cable. The following
pictures show how to install and remove it.
Figure 4. How to install the sensor.
5