Auber Instruments WS Series Instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Kontroler Auber Instruments WS Series. Auber Instruments WS Series 18 stron. Programmable pid temperature controller with dual probe
Również dla Auber Instruments WS Series: Skrócona instrukcja obsługi (15 strony), Skrócona instrukcja obsługi (14 strony), Instrukcja obsługi (18 strony), Skrócona instrukcja obsługi (14 strony)

 Plug the temperature sensor to the back of the controller.

 Plug the power cord to the power outlet on the wall.

 Turn on the controller to make sure the controller powers up properly, and the

temperature display is in the range expected. Then, turn off the controller.

 Plug the heater to the back of the controller. If the heater has a switch, put it in the

off position. Put the sensor inside the container to be controlled.

 Turn on the controller.

 Turn on the heating device.

Remark The connector of sensor contains a slot for correct pin connection. It also has a

spring lock to prevent disconnections from accidental pulling on the cable. The following

pictures show how to install and remove it.

Figure 4. How to install the sensor.