AIRTUG EL3-s Instrucciones de montaje y uso - Página 3

Navegue en línea o descargue pdf Instrucciones de montaje y uso para Scooter AIRTUG EL3-s. AIRTUG EL3-s 5 páginas.

Airtug® / 1350 Chester Industrial Parkway, Avon OH 44011 / 216-941-9781 / www.airtug.com

Note: It is recommended to have two people available for

installing the handle to the frame. Following that, it is easy for

one person to complete the assembly in a short period of

time.

Remove the shrink wrap. In addition to the tug and the

handle, the following parts are included along with the

necessary fasteners:

1. one (1) Aircraft Gear Strut Tug Strap,

2. one (1) Handle "U" Bolt,

3. two (2) Zip Ties

Step 1: Remove motor cover.

-Remove (4) 5/16 bolts, washers, and nuts.

Step 2: (Easiest with 2 people) Block up (raise) the rear of

the tug frame approximately 10".

Step 3: Install the "U" bolt on the rear of the tug frame and

leave the nuts loose for now. Remove the protective covering

from the caster wheel at the bottom of the tug handle. Install

the tug handle by pushing it through the "U" bolts (2) under

the tug frame until the caster plate meets the frame. Tighten

the "U" bolt nuts (4) securely under the tug frame. Take care

to make sure the wires at the end of the tug handle pass

through the "U" bolts as well.