ページを印刷するAirtug® / 1350 Chester Industrial Parkway, Avon OH 44011 / 216-941-9781 / www.airtug.com
Note: It is recommended to have two people available for
installing the handle to the frame. Following that, it is easy for
one person to complete the assembly in a short period of
time.
Remove the shrink wrap. In addition to the tug and the
handle, the following parts are included along with the
necessary fasteners:
1. one (1) Aircraft Gear Strut Tug Strap,
2. one (1) Handle "U" Bolt,
3. two (2) Zip Ties
Step 1: Remove motor cover.
"
"
-Remove (4) 5/16 bolts, washers, and nuts.
Step 2: (Easiest with 2 people) Block up (raise) the rear of
the tug frame approximately 10".
Step 3: Install the "U" bolt on the rear of the tug frame and
leave the nuts loose for now. Remove the protective covering
from the caster wheel at the bottom of the tug handle. Install
the tug handle by pushing it through the "U" bolts (2) under
the tug frame until the caster plate meets the frame. Tighten
the "U" bolt nuts (4) securely under the tug frame. Take care
to make sure the wires at the end of the tug handle pass
through the "U" bolts as well.
3