concept 2 DYNO Manual de instrucciones de montaje - Página 4

Navegue en línea o descargue pdf Manual de instrucciones de montaje para Gimnasios concept 2 DYNO. concept 2 DYNO 12 páginas.

Tools required

• Phillips screwdriver

• Flat blade screwdriver

• (2) 9/16" box end wrench (included)

• 1/2" box end wrench (included)

• rubber mallett (not shown) may be helpful

4a. Slide the square end of the Monorail onto

monorail extension of the Flywheel Assembly.

The Concept2 logo should appear right side up

Prop up the monorail to keep it horizontal.

NOTE: Route the chain over the top of the plastic

monorail end stop before fully assembling.

2. Attach the Push Side Foot Assembly to the

Flywheel Assembly using two of the 3/8" by 5/8"

bolts. Note the orientation of the caster wheels.

Tighten bolts.

3. Carefully remove the plastic bag that is covering

the chain coming out of the front of the Flywheel

Assembly. Allow the chain to partially unroll to the

floor. Remove the twist-tie that has been put

through the chain near the sprocket. Check that the

chain is on the small sprocket. See below.

4b. Put in the two lower 3/8" by 5/8" bolts on each

side of the Monorail as shown. Do not tighten

bolts yet. (Do not put in the top pair of bolts

yet.) If you have trouble starting the bolts,

support the Monorail from below to help align

the holes.

11/01