Anyload 110BHM3 Manual de instalación - Página 5

Navegue en línea o descargue pdf Manual de instalación para Accesorios Anyload 110BHM3. Anyload 110BHM3 7 páginas. Weigh module

Step 2:

Insert the cotter pin in the hole at the end of straight pin, and open the cotter

pin with the plier. Keep the load cell in the middle of clevis, do not brush with

the clevis . As shown in the figure below.

Notice:

The angle of Cotter pin is 60 °in principle.

The cotter pin must be okey at a time, cannot be used again and again.

Step 3:

Repeat step 1 and step 2. Install the second clevis to the other end of the load

cell, on straight pins and cotter pin. As shown in the figure below.

AL-Instruction-Weigh Module-110BHM3-12/13

Page 5 of 7