Anyload 110BHM3 설치 매뉴얼 - 페이지 5

{카테고리_이름} Anyload 110BHM3에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Anyload 110BHM3 7 페이지. Weigh module

페이지 인쇄
Anyload 110BHM3 설치 매뉴얼
Step 2:
Insert the cotter pin in the hole at the end of straight pin, and open the cotter
pin with the plier. Keep the load cell in the middle of clevis, do not brush with
the clevis . As shown in the figure below.
Notice:
The angle of Cotter pin is 60 °in principle.
The cotter pin must be okey at a time, cannot be used again and again.
Step 3:
Repeat step 1 and step 2. Install the second clevis to the other end of the load
cell, on straight pins and cotter pin. As shown in the figure below.
AL-Instruction-Weigh Module-110BHM3-12/13
Page 5 of 7