Danby DDW2405BL Manual de instrucciones de instalación - Página 3
Navegue en línea o descargue pdf Manual de instrucciones de instalación para Lavavajillas Danby DDW2405BL. Danby DDW2405BL 13 páginas. Built-in
También para Danby DDW2405BL: Manual de instrucciones de instalación (13 páginas)
Imprimir página
INSTALLATION
PREPARATION
PREPAREDISHWASHER ENCLOSURE
34-1/2 to 35"
Underside of
Countertop
to Floor
Figure 1
Floor must be
even with
room floor,
Plumbing
and
Electric Service
Must Enter
Shaded Area
Cabinets
Square
and
Plumb
• The rough cabinet opening must be at least
24" deep and to 24" wide. The opening
should be to 35" max height.
• The dishwasher
must be installed
so that the
drain hose is no more than 10 feet in length for
proper drainage.
• The dishwasher
must be fully enclosed
on the
top, side and back, and must not support
any
part of the enclosure.
CLEARANCES:
When
installed into a corner,
allow 2" min. clearance
between dishwasher and
adjacent cabinet, wall or
other appliances. Allow
25-5/8" rain. clearance
from the front of the dish-
washer for the door
opening. Fig. 2
Countertop
_5/8"
/_..Clearance
for Door
/
Opening 2" Minimum
Figure 2
DRAINREQUIREMENTS:
• Follow local codes and ordinances.
• Do not exceed 10 feet in distance to the drain.
• Do not connect drain lines from other devices
to the dishwasher drain hose.
• Dishwasher must be connected to waste line
with an air gap (not supplied) or 32" minimum
high drain loop, depending on local codes and
ordinances to prevent back flow into the dish-
washer. Air gap must be used if waste tee or
disposer connection is less than 18" above the
floor to prevent siphoning.
DRAINPREPARATION:
The type of drain installation depends on answers
to the following questions:
[]
Do local codes or ordinances require installation
of an air gap?
[]
Will waste tee or disposer connection be less
than 18" above the floor?
If the answer to ANY of the 2 questions above is
YES, METHOD 1 MUST BE USED. Otherwise
either Method 1 or Method 2 may be used.
Fig. 3 or Fig. 4
_
CAUTION:
An air gap MUST BE USED if the drain hose is
connected to waste tee or disposer lower than 18"
above the floor.
Failure to provide the proper drain connection
height with an air gap or 32" minimum high
drain loop will result in improper draining of
the dishwasher.
Method1 Air Gap with WasteTeeor disposer
Figure 3
Method2 High Drainwith Waste
Teeor Disposer
Provide a method to attach drain hose to
underside of countertop.
Mlin'
'i' I I '
k_] "1"8" M_
m
m
Figure4
CABINETPREPARATION:
• Drill a 1-1/2" dia. hole in the cabinet wall within the
shaded areas shown in Fig. 1 for drain hose
connection. The hole should be smooth with no
sharp edges.