Airwalk EdgePoint PRO Manual de referencia - Página 11
Navegue en línea o descargue pdf Manual de referencia para Punto de acceso inalámbrico Airwalk EdgePoint PRO. Airwalk EdgePoint PRO 15 páginas.
También para Airwalk EdgePoint PRO: Manual de instalación (19 páginas)
Imprimir páginaStep Five – Powering Up the EdgePoint PRO
•
Once all cable connections are established,
press the Power button on the top right side of
the device
It will take between 5 to 45 minutes for the
It will take between 5 to 45 minutes for the
•
EdgePoint PRO to configure and be ready for
service
The blue lights will illuminate to indicate:
•
POW Power is on
POW – Power is on
LINK ‐ Ethernet access is established
NET – IP Security is established
GPS The GPS location is identified
GPS – The GPS location is identified
SYS – All radios are ready and the system is
ready for operation.
1/24/2011
EdgePoint PRO Power Up Sequence
Activity (chronological)
1. Power on
2 Ethernet Access Established
LINK Led: Blue if physically connected. Blinking per activity
3. IP Sec Tunnel Connected
NET Led: Red flashing until getting DHCP IP address, Blue flashing
while IPSec tunnel is established,red if authentication fails
4. GPS Lock Established
GPS Led: Red if no satellite, Blue blinking with satellite, Blue if locked
5. System Reboot
6. SIP Registration &
Calibration
SYS Led: Blue flashing until SIP registered for 1x and/or PDSN keep alive for
7. Frequency Lock & System
Ready
AirWalk Communications Proprietary and Confidential
POW
LINK
Blue
Off
Blue
Blue
Blue
Blue
Blue
Blue
Blue
Off
Blue
Blue
DO R d bli ki
DO, Red blinking if the bandwidth is not enough for a call
if th b
d idth i
t
Blue
Blue
NET
GPS
SYS
Blue
Off
Off
Flashing
As soon as network cable is connected.
Blue
Off
Off
Flashing
1‐2 minutes
Blue
Blue
Off
Flashing
Flashing
Up to 20 minutes
Blue
Blue
Blue
Flashing
10‐15 minutes
Off
Off
Off
Up to 2 minutes
Blue
Blue
Blue
Flashing
Up to 2 minutes
Up to 2 minutes
h f
ll
Blue
Blue
Blue
Page 11