Airwalk EdgePoint PRO 참조 매뉴얼 - 페이지 11

{카테고리_이름} Airwalk EdgePoint PRO에 대한 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Airwalk EdgePoint PRO 15 페이지.
Airwalk EdgePoint PRO에 대해서도 마찬가지입니다: 설치 매뉴얼 (19 페이지)

페이지 인쇄

Step Five – Powering Up the EdgePoint PRO

•

Once all cable connections are established,

press the Power button on the top right side of

the device

It will take between 5 to 45 minutes for the

•

EdgePoint PRO to configure and be ready for

service

The blue lights will illuminate to indicate:

•

POW Power is on

POW – Power is on

LINK ‐ Ethernet access is established

NET – IP Security is established

GPS The GPS location is identified

GPS – The GPS location is identified

SYS – All radios are ready and the system is

ready for operation.

1/24/2011

EdgePoint PRO Power Up Sequence

Activity (chronological)

1. Power on

2 Ethernet Access Established

LINK Led: Blue if physically connected. Blinking per activity

3. IP Sec Tunnel Connected

NET Led: Red flashing until getting DHCP IP address, Blue flashing

while IPSec tunnel is established,red if authentication fails

4. GPS Lock Established

GPS Led: Red if no satellite, Blue blinking with satellite, Blue if locked

5. System Reboot

6. SIP Registration &

Calibration

SYS Led: Blue flashing until SIP registered for 1x and/or PDSN keep alive for

7. Frequency Lock & System

Ready

AirWalk Communications Proprietary and Confidential

POW

LINK

Blue

Off

Blue

Off

Blue

DO R d bli ki

DO, Red blinking if the bandwidth is not enough for a call

if th b

d idth i

Blue

NET

GPS

SYS

Blue

Off

Flashing

As soon as network cable is connected.

Blue

Off

Flashing

1‐2 minutes

Blue

Off

Flashing

Up to 20 minutes

Blue

Flashing

10‐15 minutes

Off

Up to 2 minutes

Blue

Flashing

Up to 2 minutes

h f

Blue

Page 11