Audiodesign PAMX1.24 Manual del usuario - Página 3

Navegue en línea o descargue pdf Manual del usuario para Mezclador de música Audiodesign PAMX1.24. Audiodesign PAMX1.24 6 páginas.

PREESSIONAL MIXERS

SET UP MEMO

INSERT 1

INSERT 2

Photocopy this page to remind set up

PAMX1. 24

PAM

X 1. 2 4

PROFESSIONAL MIXERS

Conformity:

Audiodesign Pro products comply with presently existing directives and standards.

All Audio Design PRO products have been inspected and tested before leaving the factory and , if

properly used, they will work for many years. However, in case of any problem, please proceed in the

following way:

Contact your dealer and inform about the defect you found

In case it won't be possible to solve the problem with the dealer, the product needs to be returned,

preferably in its original packaging or in a proper packing to protect it during the transport. Purchase

documents must be produced too.

Your dealer will arrange the shipment to our service centre.

Start up:

Turn the power switch OFF.

Set "down" all GAIN AND LEVEL controls (all counter clockwise )

Center EQ controls (High - Mid - Low) and PAN controls (12 hours).

Set all push buttons in their "off" position (button up).

Set "down" all master section controls (counter clockwise and down)

Connections:

If you already know how you want to connect the mixer, go ahead and connect. If you prefer to check

operation, please follow these instructions:

Plug a microphone or a mono signal source into one of the mono channels.

Or a stereo signal source into one of the stereo channels.

Connect MAIN OUTPUTS to an amplifier (Jack Balanced).

Turn power switch on. The blue led (POWER) lights up.

Mixing:

Set the LEVEL of each channel at "0" position

Turn up "MAIN MIX" to desired level, in relation to the amplifiers / speakers you are using. Preferably,

don't exceed level "0" or "+6" on the LED indicators.

Adjust LEVEL of each channel to obtain your own mix.

If necessary, adjust tones and repeat above " set levels" procedures

General indications:

The optimum GAIN and/or LEVEL position is near to 0 while the optimum position for the MAIN MIX is

the one that don't exceed level 0 / +6 on the LED level indicators.

In case you intend to connect further sources, please take care to turn down "MAIN MIX" slider

PAMX1

Serie