- ページ 3

音楽ミキサー Audiodesign PAMX1.24のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Audiodesign PAMX1.24 6 ページ。

PREESSIONAL MIXERS
SET UP MEMO
10
INSERT 1
INSERT 2
Photocopy this page to remind set up
PAMX1. 24
PAM
X 1. 2 4
10
PROFESSIONAL MIXERS

Conformity:

Audiodesign Pro products comply with presently existing directives and standards.

Service

All Audio Design PRO products have been inspected and tested before leaving the factory and , if
properly used, they will work for many years. However, in case of any problem, please proceed in the
following way:
Contact your dealer and inform about the defect you found
In case it won't be possible to solve the problem with the dealer, the product needs to be returned,
preferably in its original packaging or in a proper packing to protect it during the transport. Purchase
documents must be produced too.
Your dealer will arrange the shipment to our service centre.

QUICK START:

Start up:
1.
Turn the power switch OFF.
2.
Set "down" all GAIN AND LEVEL controls (all counter clockwise )
3.
Center EQ controls (High - Mid - Low) and PAN controls (12 hours).
4.
Set all push buttons in their "off" position (button up).
5.
Set "down" all master section controls (counter clockwise and down)
Connections:
If you already know how you want to connect the mixer, go ahead and connect. If you prefer to check
operation, please follow these instructions:
1.
Plug a microphone or a mono signal source into one of the mono channels.
2.
Or a stereo signal source into one of the stereo channels.
3.
Connect MAIN OUTPUTS to an amplifier (Jack Balanced).
4.
Turn power switch on. The blue led (POWER) lights up.
Mixing:
1.
Set the LEVEL of each channel at "0" position
2.
Turn up "MAIN MIX" to desired level, in relation to the amplifiers / speakers you are using. Preferably,
don't exceed level "0" or "+6" on the LED indicators.
3.
Adjust LEVEL of each channel to obtain your own mix.
6.
If necessary, adjust tones and repeat above " set levels" procedures
General indications:
1.
The optimum GAIN and/or LEVEL position is near to 0 while the optimum position for the MAIN MIX is
the one that don't exceed level 0 / +6 on the LED level indicators.
2.
In case you intend to connect further sources, please take care to turn down "MAIN MIX" slider
PAMX1
Serie
3