Dangerous Music Dangerous Monitor Manual - Página 4

Navegue en línea o descargue pdf Manual para Equipos de grabación Dangerous Music Dangerous Monitor. Dangerous Music Dangerous Monitor 11 páginas.

The pinout of this connector is in the "Specifications" section of this booklet

and there is a circuit example for those who wish to set up a pair of VU

meters in the "Metering Circuits" section. The D-MTR jack feeds the

selected AES signal to a digital meter or phase scope.

The 3

group of connectors is the ANALOG IN group. There are three

stereo inputs selectable by the switch group marked "ANALOG" on the

front panel. Note that the fourth switch selects the built in D/A converter.

Next are the OUPUT amplifier feeds. There is a MAIN and MINI set of

sends to drive power amplifiers. These feeds are balanced and low

impedance feeds capable of driving long cables.

The AC IN jack is where the power supply cable goes. It is best to make sure

that the power supply is turned off before connecting this cable to avoid

arcing the contacts. There are banana jacks provided for accommodating

different grounding schemes. The chassis and audio grounds are strapped

together at the factory. This works for most cases but the jacks are provided

for situations needing a different grounding scheme. If hum or buzz

problems are encountered, please consult the chapter on "Internal Jumpers"

for hints to clear up the situation.

The 25 way 'D' connector is to connect the Dim Command from a

Dangerous MQ and other expansion capabilities.

-4-