Audiomatica CLIO FW-02 Manual de instalación - Página 10

Navegue en línea o descargue pdf Manual de instalación para Equipos de grabación Audiomatica CLIO FW-02. Audiomatica CLIO FW-02 15 páginas.

If everything is OK you should obtain a reading of circa 1V, variable between a

minimum of 0.95V and a maximum of 1.05V, which is the mean output level of a

sinusoidal signal when the system is not calibrated.

Now press the FFT

button (or CTRL-F), then press the Oscilloscope button and

finally the

GoButton.

The result you should obtain is an FFT analysis of the 1kHz sinusoid (one spectral

line @ 1kHz at 0dBV) and its time representation given by its oscillogram.

Both Multimeter and FFT results must present stable and repeatable; the

oscillogram should display a sinusoid without spikes or drops of any kind.

IMPORTANT NOTE: Only if these two initial tests gave correct results, as

described, go to the following paragraph and execute the system calibration; if you

are not able to obtain these results and they seem in any way corrupted do not

execute calibration and contact technical support.

3 CLIO INSTALLATION