Duratuf KIWI KL1 Manual de instrucciones de montaje - Página 5

Navegue en línea o descargue pdf Manual de instrucciones de montaje para Almacenamiento exterior Duratuf KIWI KL1. Duratuf KIWI KL1 16 páginas.

Note:

For sheds with the Raised Floor Modification option the studs will be 1.780m long to allow the Wall Sheets to pro-

trude 20mm below the Bottom Plate. Refer to Raised Floor Modification section (Page 15).

Note:

Studs and Nogs surrounding a window opening are to be fitted once the wall cladding is nailed in place.

Step 1: End Walls: Select one 1.210m End Base Plate

(Green), one 1.210m End Top Plate (Red) and

two Studs (Yellow). Lay out Plates and two Studs

on a flat surface and nail together using two

75mm nails per join. Position 1.120m Nog .883m

down from Top Plate and nail in place. Repeat

with other end wall.

Step 2: Select one 1.715m Base Plate (Green), one

1.715m Top Plate (Red). Stand up End frame

with the Stud side of the frame on the ground.

Nail 1.715m plates to frame using two nails per

join. Ensure Green joins to Green and Red joins

to Red. Repeat with other end frame. Position

1.625m Back Wall Nog .883m down from the

Top Plate and nail in place.

Step 3: Select one 1.715m Base Plate (Green) and the

Ridge Beam (90 x 45). Nail in place. Ensure

Green joins to Green.

Step 4: Carefully roll the frame over so that the Ridge

Beam and Base Plate (Green) are on the

ground. Select a stud (Yellow) and one .785m

Nog. Nail in Stud using the .785m nog to get the

correct

position

nog .883m down from the Top Plate and nail in

place.

Step 5: Carefully roll frame over onto its base. If fitting a

Kiwi Floor, fit Floor Joists now. Place the joist

centrally and nail in place using three 75mm nails

per end.

KL1 TIMBER FRAME

top

and

bottom.

Position