Addonics Technologies ZESSIU3CS Manual del usuario - Página 2

Navegue en línea o descargue pdf Manual del usuario para Recinto Addonics Technologies ZESSIU3CS. Addonics Technologies ZESSIU3CS 2 páginas. Z usb3.0 / esata combo drive enclosure for sata or ide hard drive or optical drive

Imprimir página
B. Installing a 3.5" IDE hard drive
The Z USB3.0 / eSATA combo drive enclosure comes with an IDE to
SATA converter.
SATA Port
4-Pin Floppy
Power
Note: It is required to set up the IDE hard drive you are connecting to
the converter as a MASTER device.
1.
Locate the 40-pin IDE connector of your IDE drive.
40-pin IDE Connector
2.
Connect the converter board to the IDE connector of the hard drive.
3.
Using the provided Y-power cable, connect the 4-pin Molex
connector to the power connector on the hard drive. This will
provide power to the hard drive.
40-pin IDE Connector
4-pin Molex
Power Connector
Master or Slave
Jumper Settings
4.
At the other end of the Y-power cable is the 4-pin floppy power connector
which you connect to the converter. Now connect the SATA cable to the
SATA port on the converter.
5.
Disconnect the SATA board from the drive enclosure. Then connect the
SATA cable to the SATA port on the IDE to SATA converter
SATA board
ADSAIDE
IDE to
SATA converter
Step 3
Use the enclosed screws to secure the hard drive to the tray.
Screw holes