- ページ 2

エンクロージャー Addonics Technologies ZESSIU3CSのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Addonics Technologies ZESSIU3CS 2 ページ。 Z usb3.0 / esata combo drive enclosure for sata or ide hard drive or optical drive

ページを印刷する

B. Installing a 3.5" IDE hard drive

The Z USB3.0 / eSATA combo drive enclosure comes with an IDE to

SATA converter.

SATA Port

4-Pin Floppy

Power

Note: It is required to set up the IDE hard drive you are connecting to

the converter as a MASTER device.

Locate the 40-pin IDE connector of your IDE drive.

40-pin IDE Connector

Connect the converter board to the IDE connector of the hard drive.

Using the provided Y-power cable, connect the 4-pin Molex

connector to the power connector on the hard drive. This will

provide power to the hard drive.

40-pin IDE Connector

4-pin Molex

Power Connector

Master or Slave

Jumper Settings

At the other end of the Y-power cable is the 4-pin floppy power connector

which you connect to the converter. Now connect the SATA cable to the

SATA port on the converter.

Disconnect the SATA board from the drive enclosure. Then connect the

SATA cable to the SATA port on the IDE to SATA converter

SATA board

ADSAIDE

IDE to

SATA converter

Step 3

Use the enclosed screws to secure the hard drive to the tray.

Screw holes