APlusLift HW-10KBP Manual de instalación y funcionamiento - Página 4

Navegue en línea o descargue pdf Manual de instalación y funcionamiento para Sistemas de elevación APlusLift HW-10KBP. APlusLift HW-10KBP 20 páginas. 2-post floor plate car lift 10,000lb capacity
También para APlusLift HW-10KBP: Manual de instalación e instrucciones de uso (16 páginas), Manual de instalación y funcionamiento (20 páginas)

APlusLift HW-10KBP Manual de instalación y funcionamiento

Installation Requirements

 Use proper lifting techniques when lifting individual pieces. Use plenty of help when
moving lift pieces. Please wear work gloves to protect your hands.
 The lift should be installed on a leveled floor with a slope of less than 3 degrees.
 Do not install this lift on asphalt, wood, or any other surface other than described.
 Do not install this lift outdoors unless special consideration has been made to protect
the power unit from inclement weather conditions.
 Do not install lift in a basement or on any level other than ground level (such as the
second floor) without written authorization from your building engineer or architect.
 Concrete surface shall have a minimum of 6" thick and 3,500 psi tensile strength with
steel or fiber mesh reinforcement (If you always lift vehicles below 9,000LB, 4" thick
concrete will be fine). Minimum size of a slab: 216"L x 100"W x 6"H 3500 psi.
 Alternatively, columns can be installed on two concrete footings. 2 ft x 2 ft with 30"
deep (or 3 ft x 3 ft with 12" deep) and 3500 psi tensile strength with steel or fiber mesh
reinforcement.
 Maintain a 6" minimum distance from a slab edge. Do not install this lift over expansion
joints or cracks. Check with your qualified engineer or architect.
 Leave spaces on all 4 sides when placing the lift. Recommended at least 2' distances
on all 4 sides when a vehicle is loaded.
 Improper installation can cause damage or injury. Manufacturer will assume no liability
for loss or damage of any kind, expressed or implied, resulting from improper
installation or use of this product.
 The lift is for lifting vehicles only. It is not designed to lift a person or an equipment with
a person.
 Read this installation manual in its entirely before attempting to install this lift.
 Use of this lift should follow the operation and safety guidelines set forth in this manual.
Concrete Slab
Length 216 inches
Width
100
inches
4