APlusLift HW-10KBP Manual de instalación y funcionamiento - Página 7
Navegue en línea o descargue pdf Manual de instalación y funcionamiento para Sistemas de elevación APlusLift HW-10KBP. APlusLift HW-10KBP 20 páginas. 2-post floor plate car lift 10,000lb capacity
También para APlusLift HW-10KBP: Manual de instalación e instrucciones de uso (16 páginas), Manual de instalación y funcionamiento (20 páginas)
Imprimir página
Step 1 (Preparation)
Please carefully remove all the parts from the package.
◦ Remove any loose cables, hoses, part boxes, hydraulic power unit, etc. if they are
inside the columns or banded to the columns.
◦ Remove the power unit box and four swing arms
◦ Remove the bolts holding the two columns together. Remove top and bottom
columns out of the skid and discard the steel rack.
Compare the parts with the part list (at the end of the manual) and contact us if there
are any parts missing.
Please read the installation requirements and anchoring tips in previous pages for
concrete requirement, layout, and drill holes for anchor bolts. The area where the lift
will be installed should be free of overhead obstructions such as heater, building
support, or electrical lines.
Once a location is determined, use a carpenter's chalk line to layout a grid for the
column locations
After the post locations are marked, use a chalk to make an outline of the posts on the
floor at each location using the post base plates as a template.
Double check all dimensions and make sure that the layout is perfectly square.
Installation Instructions
7