APlusLift HW-10KBP Руководство по установке и эксплуатации - Страница 7

Просмотреть онлайн или скачать pdf Руководство по установке и эксплуатации для Подъемные системы APlusLift HW-10KBP. APlusLift HW-10KBP 20 страниц. 2-post floor plate car lift 10,000lb capacity
Также для APlusLift HW-10KBP: Руководство по установке и инструкции по эксплуатации (16 страниц), Руководство по установке и эксплуатации (20 страниц)

Step 1 (Preparation)

 Please carefully remove all the parts from the package.

◦ Remove any loose cables, hoses, part boxes, hydraulic power unit, etc. if they are

inside the columns or banded to the columns.

◦ Remove the power unit box and four swing arms

◦ Remove the bolts holding the two columns together. Remove top and bottom

columns out of the skid and discard the steel rack.

 Compare the parts with the part list (at the end of the manual) and contact us if there

are any parts missing.

 Please read the installation requirements and anchoring tips in previous pages for

concrete requirement, layout, and drill holes for anchor bolts. The area where the lift

will be installed should be free of overhead obstructions such as heater, building

support, or electrical lines.

 Once a location is determined, use a carpenter's chalk line to layout a grid for the

column locations

 After the post locations are marked, use a chalk to make an outline of the posts on the

floor at each location using the post base plates as a template.

 Double check all dimensions and make sure that the layout is perfectly square.

Installation Instructions