APlusLift HW-10KBP 설치 및 운영 매뉴얼 - 페이지 7
{카테고리_이름} APlusLift HW-10KBP에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. APlusLift HW-10KBP 20 페이지. 2-post floor plate car lift 10,000lb capacity
APlusLift HW-10KBP에 대해서도 마찬가지입니다: 설치 매뉴얼 및 작동 지침 (16 페이지), 설치 및 운영 매뉴얼 (20 페이지)
페이지 인쇄
Step 1 (Preparation)
Please carefully remove all the parts from the package.
◦ Remove any loose cables, hoses, part boxes, hydraulic power unit, etc. if they are
inside the columns or banded to the columns.
◦ Remove the power unit box and four swing arms
◦ Remove the bolts holding the two columns together. Remove top and bottom
columns out of the skid and discard the steel rack.
Compare the parts with the part list (at the end of the manual) and contact us if there
are any parts missing.
Please read the installation requirements and anchoring tips in previous pages for
concrete requirement, layout, and drill holes for anchor bolts. The area where the lift
will be installed should be free of overhead obstructions such as heater, building
support, or electrical lines.
Once a location is determined, use a carpenter's chalk line to layout a grid for the
column locations
After the post locations are marked, use a chalk to make an outline of the posts on the
floor at each location using the post base plates as a template.
Double check all dimensions and make sure that the layout is perfectly square.
Installation Instructions
7