APlusLift HW-10KBP 설치 및 운영 매뉴얼 - 페이지 8

{카테고리_이름} APlusLift HW-10KBP에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. APlusLift HW-10KBP 20 페이지. 2-post floor plate car lift 10,000lb capacity
APlusLift HW-10KBP에 대해서도 마찬가지입니다: 설치 매뉴얼 및 작동 지침 (16 페이지), 설치 및 운영 매뉴얼 (20 페이지)

페이지 인쇄

Step 2 (Installing Columns)

 Determine the side that the power unit column will be located. The power unit column

can be located on either side. Keep in mind this is the column where your main

electrical power supply will be connected. It is recommended to locate the power side

with the passenger side of the vehicle when loaded on the lift in order to save steps

during operation.

 Double check measurements and make sure that the base plate of each column is

square and aligned with the chalk line.

 Stand up the power unit column (the one with the power unit bracket welded on) and

position it inside the chalked lines. The column should face straight toward the other

column.

 Stand up the other column opposite to the main power unit column inside the chalk

lines.

 Make sure the height difference of two columns is within 1 inch, otherwise the

carriages will not be locked at the same (height) locking positions.

 Place the floor plate between two columns and align the mounting holes with the inside

base plate holes. This will make sure proper spacing between columns.

 Please note the floor plate is not bolted to columns or ground.

 Using a tape to measure from back corner to back corner of the base plate to ensure

columns are square to each other. Adjust columns as needed to obtain the best fit.

 Drill holes with 3/4 inch drill bit into concrete following Anchoring Tips on page 4.

 Assemble washers and nuts on the anchors and then tap into each hole with a rubber

hammer until washers rest against the base plate. Do not tighten anchor bolts at this

time.

 Use a level to check the level of each base plate. Place horseshoe shims under the

base plate (near anchor bolts) as needed. When base plates are leveled, columns may

tilt outward slightly. When a vehicle is loaded, the columns will flex inward to correct it.

 Tighten 10 anchor bolts and recheck for level. Hammer the anchor bolts all the way

down. Tighten anchor bolts using a torque wrench to 125 ft. / lb. DO NOT use an

impact wrench when tightening the anchor bolts!

 Now remove the steel floor plate cover.

 Manually lift the carriage on each column about waist high. Let carriages down and

allow them to set on safety latch stops. Make sure they are at the same height. Double

check the latches before working under the carriages.