Apogee Atomizer 05054 Manual de inicio rápido - Página 5

Navegue en línea o descargue pdf Manual de inicio rápido para Juguete Apogee Atomizer 05054. Apogee Atomizer 05054 8 páginas.

17. Find the white cotton shroud line and cut the string

into three equal lengths as shown. Tie the shroud

lines through the ring holes as shown. Put a little bit of

glue on the knots to secure them in place. Allow the

glue to dry.

18. Holding the parachute at the center of its top, pull

the lines together to even up the ends. Thread the

three looped lines through the plastic loop at the base

of the nose cone (1). Take the top of the parachute

and thread it through all three string loops (2). Finally,

pull on the tip of the canopy to tighten the knot (3).

This securely attaches the parachute to the rocket.

19. When all the glue has completely dried, you can

paint the components of the Atomizer rocket. Roll a

piece of paper and insert it into the motor mount tube

so you can hold the model while painting it. For best

results, paint the parts with primer before using the fi-

nal color paint. Follow the directions on the paint can,

and always paint outdoors with the wind against your

back. Let the paint harden at least 24 hours before

proceeding.

20. Test the fit of the large ring over the fins. If nec-

essary, sand down the edge of the fins to achieve

a snug fit. Once the ring fits nicely, glue it in place

using the CyA Adhesive (super glue - medium or thick

viscosity).

21. Allow the paint to harden at least 1 day before

applying the vinyl decals. We recommend removing

each one from the paper backing and then dipping

them in soapy water to lubricate them so they will

slide around and can be repositioned easily. Keep

them wet by occasionally dripping some soapy water

on the model if they start to grab the rocket too quick-

ly. When the decal is in the right location, press down

firmly, and squeegee out any water underneath. When

the decal dries, it will be permanently fixed. The soapy

water will not affect the adhesion of the glue on the

back of the vinyl decal.

Congratulations! Your Atomizer rocket is now com-

plete!

Step 17

Step 18

Step 19

Step 20

Step 21

Page 5