Elsat iNode Manual de instrucciones - Página 6

Navegue en línea o descargue pdf Manual de instrucciones para Transceptor Elsat iNode. Elsat iNode 15 páginas. Serial transceiver usb

iNode Serial Transceiver USB – instruction manual

The picture below shows the UART tab:

The following items can be set:

Baud rate: select the speed of the physical UART connectors on the module. The default speed



for iNode Serial Transceiver USB is 921,600 bps. It can be set in the range from 2400 bps to

3,686,400 bps.

Frame: specifies the parameters of the frame data byte-the number of bits, parity and number of



stop bits. Possible values: 8N1, 8N2, 8E1, 8E2, 8O1, 8O2.

Timeout: if UART doesn't receive a new character in this time the BLE frame will be sent with



all characters received earlier.

EOL character: the character that causes the sending data: Specifies what character received by



the UART will send the data via BLE.

Mode: allows you to select the operating mode of the device:



Scan mode: in this mode, the device does not broadcast advertisement frames but is ready to



receive commands by UART.

Standby mode: in this mode, the device broadcasts advertisement BLE frames and wait for



the connection. You can connect to it and send the data over the UART.

Notwithstanding the above settings, the data are sent by BLE when the UART buffer is full, or in

packs of 20 bytes. This is the Bluetooth Low Energy standard.

You can save modified settings by pressing the Write button.

ELSAT s.c.

page 6