Elsat iNode Instruction Manual - Page 6
Browse online or download pdf Instruction Manual for Transceiver Elsat iNode. Elsat iNode 15 pages. Serial transceiver usb
Print PageiNode Serial Transceiver USB – instruction manual
The picture below shows the UART tab:
The following items can be set:
Baud rate: select the speed of the physical UART connectors on the module. The default speed
for iNode Serial Transceiver USB is 921,600 bps. It can be set in the range from 2400 bps to
3,686,400 bps.
Frame: specifies the parameters of the frame data byte-the number of bits, parity and number of
stop bits. Possible values: 8N1, 8N2, 8E1, 8E2, 8O1, 8O2.
Timeout: if UART doesn't receive a new character in this time the BLE frame will be sent with
all characters received earlier.
EOL character: the character that causes the sending data: Specifies what character received by
the UART will send the data via BLE.
Mode: allows you to select the operating mode of the device:
Scan mode: in this mode, the device does not broadcast advertisement frames but is ready to
receive commands by UART.
Standby mode: in this mode, the device broadcasts advertisement BLE frames and wait for
the connection. You can connect to it and send the data over the UART.
Notwithstanding the above settings, the data are sent by BLE when the UART buffer is full, or in
packs of 20 bytes. This is the Bluetooth Low Energy standard.
You can save modified settings by pressing the Write button.
ELSAT s.c.
page 6