Elsema Gigalink GLR2708 Instrucciones de instalación y programación - Página 8
Navegue en línea o descargue pdf Instrucciones de instalación y programación para Receptor Elsema Gigalink GLR2708. Elsema Gigalink GLR2708 8 páginas. 8-channel 27mhz receiver with open collector outputs
También para Elsema Gigalink GLR2708: Manual (7 páginas)
Imprimir página
TROUBLESHOOTING
This section contains helpful troubleshooting tips and solutions.
Symptom
Receiver not responding to transmitter
after programming.
Transmitter activates wrong channel
on a multi-channel receiver.
Transmitter has short range.
LED is flashing on the transmitter.
CUSTOMER SUPPORT
If your transmitter and receiver are still not operating properly, contact Elsema's support office at:
Phone:
+61 (2) 9609 4668
Fax:
+61 (2) 9725 2663
or you can visit our web site at www.elsema.com for the latest updates.
ELSEMA PTY LTD
31 Tarlington Place
Smithfield NSW 2164 Australia
P 02 9609 4668
F 02 9725 2663
W www.elsema.com
Solution
Try to program the transmitter again, but this time with the battery
connected to the transmitter.
Check if GIGALINK
cable is inserted correctly.
™
Wrong dipswitch setting while programming the receiver. Use the
dipswitch table and program again.
Check receiver antenna connection. If you are using a shielded coax
cable, check that the shield is connected to the negative and the
coaxial core to the antenna terminal.
Replace battery.
Local Distributor