Elsema Gigalink GLR2708 설정 및 프로그래밍 지침 - 페이지 8
{카테고리_이름} Elsema Gigalink GLR2708에 대한 설정 및 프로그래밍 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Elsema Gigalink GLR2708 8 페이지. 8-channel 27mhz receiver with open collector outputs
Elsema Gigalink GLR2708에 대해서도 마찬가지입니다: 매뉴얼 (7 페이지)
페이지 인쇄
TROUBLESHOOTING
This section contains helpful troubleshooting tips and solutions.
Symptom
Receiver not responding to transmitter
after programming.
Transmitter activates wrong channel
on a multi-channel receiver.
Transmitter has short range.
LED is flashing on the transmitter.
CUSTOMER SUPPORT
If your transmitter and receiver are still not operating properly, contact Elsema's support office at:
Phone:
+61 (2) 9609 4668
Fax:
+61 (2) 9725 2663
or you can visit our web site at www.elsema.com for the latest updates.
ELSEMA PTY LTD
31 Tarlington Place
Smithfield NSW 2164 Australia
P 02 9609 4668
F 02 9725 2663
W www.elsema.com
Solution
Try to program the transmitter again, but this time with the battery
connected to the transmitter.
Check if GIGALINK
cable is inserted correctly.
™
Wrong dipswitch setting while programming the receiver. Use the
dipswitch table and program again.
Check receiver antenna connection. If you are using a shielded coax
cable, check that the shield is connected to the negative and the
coaxial core to the antenna terminal.
Replace battery.
Local Distributor