Dust Free 04401MV Manual de instalación y funcionamiento - Página 3

Navegue en línea o descargue pdf Manual de instalación y funcionamiento para Limpiador de aire Dust Free 04401MV. Dust Free 04401MV 8 páginas. Ultraviolet light systems

BIO-FIGHTER
®
NOMAD, NOMAD 2 INSTALLATION & OPERATION MANUAL
IMPORTANT:
The device must be installed in compliance
with all national and local electrical and
mechanical codes. Failure to do so will void
ETL safety listing and Dust Free® warranty.
SPECIAL INSTALLATION NOTES
• Do not install in closet return grille applications.
• Do not in outdoor applications.
• Do not expose wiring or plastic parts to UV-C light.
• Do not install where UV-C light can be seen
after installation.
• Do not install beneath a humidifier.
• If the UV device is installed on the inlet side
(return air side) of a coil, make sure that the
HVAC system is configured such that the
blower is located between the return air filter
and the inlet side (return air side) of the coil,
such as would be found in a traditional up-
flow, or horizontal furnace with the coil
placed after the heat exchanger.
• If the UV device is installed near an air filter,
check with filter manufacturer for UV-C
resistance properties.
• If the desired UV installation location is
intended to irradiate an air filter, to neutralize
the microbiological matter on the air filter
surface, such as would be found in the
return air drop of a basement application or
in the return plenum of a horizontal system
in an attic; take precautions as described in
note above, and make sure the UV fixture is
placed on the return side of the filter. DO
NOT INSTALL THE UV FIXTURE ON EITHER
SIDE OF THE FILTER IN HALL / CLOSET
RETURN AIR APPLICATIONS.
TION! Warning sheet #212945-00).
Nomad/Nomad 2 Mounting Options
The Nomad/Nomad 2 is suitable for installa-
tion inside or outside the air handling system
or ductwork. For HVAC applications only.
The Nomad/Nomad 2 may be installed as a
parallel mount, perpendicular mount, or as an
insert mount depending on your requirements.
The included brackets and screws allow the
device to be mounted in any of these orienta-
tions.
Note: For insert-mount applications a 3" hole must be
cut into the duct to allow for the insertion of the lamp
and connector.
Perpendicular
Mount
Parallel
Mount
(Nomad Only)
Insert
Mount
(See ATTEN-
Fig. 1 Device may be mounted in a variety of orientations.
Sharp Edge Hazard.
Be careful of sharp edges on device and HVAC equip-
ment while installing the device. Personal injury may
result.
3
CAUTION
(Fig.1)