Dust Free 04401MV Panduan Pemasangan & Pengoperasian - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Pemasangan & Pengoperasian untuk Pembersih Udara Dust Free 04401MV. Dust Free 04401MV 8 halaman. Ultraviolet light systems

Halaman Cetak

BIO-FIGHTER

NOMAD, NOMAD 2 INSTALLATION & OPERATION MANUAL

IMPORTANT:

The device must be installed in compliance

with all national and local electrical and

mechanical codes. Failure to do so will void

ETL safety listing and Dust Free® warranty.

SPECIAL INSTALLATION NOTES

• Do not install in closet return grille applications.

• Do not in outdoor applications.

• Do not expose wiring or plastic parts to UV-C light.

• Do not install where UV-C light can be seen

after installation.

• Do not install beneath a humidifier.

• If the UV device is installed on the inlet side

(return air side) of a coil, make sure that the

HVAC system is configured such that the

blower is located between the return air filter

and the inlet side (return air side) of the coil,

such as would be found in a traditional up-

flow, or horizontal furnace with the coil

placed after the heat exchanger.

• If the UV device is installed near an air filter,

check with filter manufacturer for UV-C

resistance properties.

• If the desired UV installation location is

intended to irradiate an air filter, to neutralize

the microbiological matter on the air filter

surface, such as would be found in the

return air drop of a basement application or

in the return plenum of a horizontal system

in an attic; take precautions as described in

note above, and make sure the UV fixture is

placed on the return side of the filter. DO

NOT INSTALL THE UV FIXTURE ON EITHER

SIDE OF THE FILTER IN HALL / CLOSET

RETURN AIR APPLICATIONS.

TION! Warning sheet #212945-00).

Nomad/Nomad 2 Mounting Options

The Nomad/Nomad 2 is suitable for installa-

tion inside or outside the air handling system

or ductwork. For HVAC applications only.

The Nomad/Nomad 2 may be installed as a

parallel mount, perpendicular mount, or as an

insert mount depending on your requirements.

The included brackets and screws allow the

device to be mounted in any of these orienta-

tions.

Note: For insert-mount applications a 3" hole must be

cut into the duct to allow for the insertion of the lamp

and connector.

Perpendicular

Mount

Parallel

Mount

(Nomad Only)

Insert

Mount

(See ATTEN-

Fig. 1 Device may be mounted in a variety of orientations.

Sharp Edge Hazard.

Be careful of sharp edges on device and HVAC equip-

ment while installing the device. Personal injury may

result.

CAUTION

(Fig.1)