elsner elektronik KNX LW sl Especificaciones técnicas e instrucciones de instalación - Página 10
Navegue en línea o descargue pdf Especificaciones técnicas e instrucciones de instalación para Accesorios elsner elektronik KNX LW sl. elsner elektronik KNX LW sl 13 páginas. Brightness and wind sensor
Imprimir página
2.4.4. Closing the installation
2.5. Instructions for assembly and initial start-up
Remove all transport protection stickers present after installation.
The wind measurement value and thus also all wind switching outputs cannot be out-
put until 35 seconds after the power is turned on.
Brightness and Wind Sensor KNX LW sl • Status: 05.11.2014 • Errors excepted. Subject to technical changes.
10
Fig. 14
Connect
KNX data (+|-) and
power supply (12...40V DC, 12...28V AC, 1|2)
to the connector.
The terminal assignment of the power supply
is polarity-independent.
KNX
Voltage
-
+
1
2
-
+
1
2
Fig. 15
Push the lid on the lower part. This also
makes the plug-in connection between the
board in the lid and the socket in the lower
part.
Fig. 16
Screw the lid (top) and lower part (bottom) to-
gether.
Installation and start-up