elsner elektronik KNX LW sl Especificaciones técnicas e instrucciones de instalación - Página 8
Navegue en línea o descargue pdf Especificaciones técnicas e instrucciones de instalación para Accesorios elsner elektronik KNX LW sl. elsner elektronik KNX LW sl 13 páginas. Brightness and wind sensor
Imprimir página
Cable guide
Rubber
gasket
Drilling plan
ATTENTION! The printout of the data sheet does not have original size! A separate, di-
mensionally correct drilling plan is included ex works and this can be used as a tem-
plate.
Brightness and Wind Sensor KNX LW sl • Status: 05.11.2014 • Errors excepted. Subject to technical changes.
8
Fig. 9 a+b
a) If the power lead is to be hidden when in-
stalled, it must emerge from the wall in
the vicinity of the rear of the housing
(marked area).
b) If the power lead is to be surface-mount-
ed, the cable guide is broken off. The lead
is then fed into the device at the under-
side of the housing.
Fig. 10
Feed the power lead through the rubber gas-
ket.
Installation and start-up