CB2 HYDE Instrucciones de montaje - Página 4
Navegue en línea o descargue pdf Instrucciones de montaje para Mobiliario interior CB2 HYDE. CB2 HYDE 4 páginas. Square open wall ccabinet
También para CB2 HYDE: Instrucciones de montaje (4 páginas), Instrucciones de montaje (5 páginas)
Imprimir páginahyde
SQUARE OPEN WALL CABINET
wall mounting assembly
wall template
wall bracket
The wall mounting hardware included with this wall cabinet is intended for drywall installation only. Be sure to
use hardware appropriate for your wall type. Whenever possible, fasten screws directly into a wall stud. If you are
unsure about your wall type or what mounting method you should use, consult a qualified professional or your local
hardware store.
1. Determine the wall cabinet orientation and wall location. Using a level for the provided
and mark hole positions for wall bracket as shown.
2. If attaching directly into wall studs, skip to Step 4.
3. For drywall installation, drill a hole slightly smaller in diameter than the anchor. Insert 1 plastic anchor at each
marked hole location and gently tap with a hammer until the head of each anchor is flush to the wall surface.
4. Insert 1 large screw through each hole in the wall bracket and into the corresponding anchors or studs in the
wall. Fully tighten each screw with a phillips head screwdriver but do not over tighten.
5. With the assistance of another adult, fit the bracket on the back of the unit onto the wall bracket. Make sure the
unit is firmly seated in the wall bracket.
Wall attachment is now complete.
Made in Vietnam - r03
wall attachment
bracket
Customer Service 800.606.6252 | Latest instructions available on www.cb2.com
wall attachment
bracket pre-installed
on cabinet
Discard wall template.
BACK OF
ASSEMBLY
wall template, level
Page 4 of 4