CB2 HYDE 조립 지침 - 페이지 4

{카테고리_이름} CB2 HYDE에 대한 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. CB2 HYDE 4 페이지. Square open wall ccabinet
CB2 HYDE에 대해서도 마찬가지입니다: 조립 지침 (4 페이지), 조립 지침 (5 페이지)

페이지 인쇄

hyde

SQUARE OPEN WALL CABINET

wall mounting assembly

wall template

wall bracket

The wall mounting hardware included with this wall cabinet is intended for drywall installation only. Be sure to

use hardware appropriate for your wall type. Whenever possible, fasten screws directly into a wall stud. If you are

unsure about your wall type or what mounting method you should use, consult a qualified professional or your local

hardware store.

1. Determine the wall cabinet orientation and wall location. Using a level for the provided

and mark hole positions for wall bracket as shown.

2. If attaching directly into wall studs, skip to Step 4.

3. For drywall installation, drill a hole slightly smaller in diameter than the anchor. Insert 1 plastic anchor at each

marked hole location and gently tap with a hammer until the head of each anchor is flush to the wall surface.

4. Insert 1 large screw through each hole in the wall bracket and into the corresponding anchors or studs in the

wall. Fully tighten each screw with a phillips head screwdriver but do not over tighten.

5. With the assistance of another adult, fit the bracket on the back of the unit onto the wall bracket. Make sure the

unit is firmly seated in the wall bracket.

Wall attachment is now complete.

Made in Vietnam - r03

wall attachment

bracket

Customer Service 800.606.6252 | Latest instructions available on www.cb2.com

wall attachment

bracket pre-installed

on cabinet

Discard wall template.

BACK OF

ASSEMBLY

wall template, level

Page 4 of 4